POSSIBLE REASONS:
1.Cable contact does not reach the designated position or loose
2.Power supply or video input terminal INT
3.Video system error
3.Other hardware failure
SOLUTIONS: Remove failures
White image
1.Lens type error(e.g.manual lens setas DC lens in OSD menu)
2.Image brightness adjusts too high
3.BLC on
4.DC lens cable INT
SOLUTIONS:Adjust/reset
5.DC lens brokendown
6.Other hardware failure
SOLUTIONS:Remove failures
ICR switching failure
1.Box camera ICR module:
half color half black and white image,
ICR may be jamed in the middle of the module after strong shock Re-power up after
slight shock
2.Seeting error: Day/Night(with CDS) mode set as EXT, Day/Night(without CDS) mode set as AUTO
3.Other hardware failure.
SOLUTIONS:Adjust/reset
Image blurred , unclear
or hole existed 1.Front glass or lens dirty
2.The transparent cover wore away
3.Lens lost focus,adjust the focus
4.Other hardware failure.
SOLUTIONS:Clean and readjust it
the transparent cover
should be cleaned with
clean soft cotton
Vehicle licence plate
camera can not catch
the vehicle licence
1.Shutter speed should be set from 1/500 to 1/1000 or less
while monitoring fast moving vehicles
2.White light brightness is too low
SOLUTIONS: Reset the parameter
DC lens reboot again
and again or
fail to turn on 1.Lens failure
2.Box camera with DC/VIDEO switch in gear pennal,
when transferred to "VIDEO", image will be white
SOLUTIONS:Adjust it